Key Features

• 16 Channel Monitor
• Clear LCD indication
• Auto-reset following power failure
• Fire Alarm test bypass timer
• 24VDC auxiliary power output to power up to 4-6 Flamefast Gas Sensors dependant on sensor type External power supply required for additional
• Additional Interfaces for:
  • Thermal Links, Ventilation Systems, Remote Emergency Stop Buttons and Fire Alarm Systems
• Sensor calibration reminder
• Alarm 1, Alarm 2 and Fault relays
• Selectable relay latching function
• 5 Year Warranty
• UK MANUFACTURED

Technical Specification

External Device Interfaces

Dimensions

Basic Operation

The GasMonitor has three buttons on the front:

Reset - The GasMonitor Alarm 1 and 2 relays are activated depending on the sensor conditions. Once an alarm has cleared the reset button can be used to reset any relays that are set to latch this will also reset the Gas Valve output which will shut down if any sensor reaches Alarm 2.

Mute - If there are any gas alarms, this can be used to silence the panel for 10 minutes. If this is held in for 10 seconds, this will also reset any non-latching alarm relays for 2 minutes.

Test - The operation of the Test button is dependent on the panel status:

• If the panel is live without any alarm conditions, holding this button in for 10 seconds will enable the Fire Alarm bypass. The Fire Alarm interface will be ignored for 30 minutes to allow tests to be carried out.
• Following an alarm (prior to reset), holding the Test button for 5 seconds each will change the state of the Alarm 1, Alarm 2 and Fault relays.

Installer Selectable Options

• Energise relays (Failsafe)
• Auto-reset
• Alarm 1 Latching
• Alarm 2 Latching

Part Numbers & Options / Accessories